Cart 0
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA
Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA

Universal BMS CANflex CANbus E85 Analyzer (ECA) BETA

  • Save $50
Shipping calculated at checkout.

This universal E85 analyzer plugs directly into your Flex Fuel sensor (sensor kit sold separately) and outputs your ethanol reading on CANbus allowing your flash only DME and/or JB4 to read the ethanol signal. In addition it includes a harness plug for an optional low fuel pressure sensor (available from Fuel-It!) adding this critical tuning information to platforms like the B58 that don't include a factory low fuel pressure sensor.

CANflex is now also available with an LED readout! Route the new display box inside the cabin or glove box for a quick glance of your ethanol mixture or leave it in the engine bay under a plastic cover as a backup plan. Note the LED display is not water-proof and care should be taken to ensure it doesn't get soaked! CANflex LED has a dial inside that allows you to change between CANbus address modes for MHD, BM3, and JB4. Offered with the universal harness only.


Can be used with both rear mount and front mount sensor kits. Universal CANbus connections are attached using removable posi-taps based on mounting location. See wiring guide below.


    Wiring Guide for universal original harness
    Red/Green: 12v switched power via fuse tap or posi-tap
    Black: Ground
    Orange: CAN- (For front mount usually the factory yellow CANbus wire)
    Red/Blue: CAN+ (For front mount usually the factory red CANbus wire)

    Harness types:

    1. Universal harness, this is a universal harness for use with JB4, BM3, MHD, ECUtek, etc. Installs using included removable posi-taps.
    2. PnP harness, this harness is a plug and play option with the following requirements.
      1. It is only compatible with the BMW GEN2 B58 and S58 platforms with automatic transmissions.
      2. You must be running a JB4, MHD, ECUtek, or similar tune
      3. Flex fuel kit must be mounted in the engine bay near the ECU, rear mounted flex fuel kits must use the universal harness
      4. Note BM3 is not compatible with the PnP harness and requires our universal harness!

    Diagnostic LED:
    Solid green: Unit has power/ground
    Flashing green: Unit has power/ground and CANbus communication

    Note: We can customize the transmit address, format, and transmit
    speed. Contact us if you have a special request.

    BMS Universal Canbus E85 Analyzer Installation and review