BMS 3.7" Billet Exhaust Tips for F10 BMW 535 (Pair) ***Out of stock***
Upgrade your F10/F07 535 BMW to Larger 3.7" Angle Cut Billet Tips
Bolt on a custom look with these 3.7" billet exhaust tips for your F10/F07 535 BMW. 25% bigger than stock these unique billet tips are sure to turn heads. Machined from a solid block of billet aluminum and equipped with set screws so they go on easily and stay in place. No clamps for a clean appearance. Available in Matte Black Ceramic. Not for use with M-Performance exhaust systems.
Ceramic Black is the ultimate exhaust finish. Ceramic coating can withstand extreme temperatures up to 1200º F (649º C) and provides a durable and great looking finish that rivals OEM quality and longevity. Made in the USA.
Replaces OE BMW Part # 18307594919, 18-30-7-594-919, 18 30 7 594 919
Applications
BMW 5 Series
• 2011-2016 N55 BMW F10 F11 535i/535ix and 535d/535d xdrive
• 2011-2015 N55 BMW F07 535i/ix GT
To install remove your factory tips by pounding outward on the lower rear part of the tip with either a rubber mallet or a hammer. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small to medium taps will start the factory tip sliding off the actual exhaust pipe. You can spray some lubricant in there to make it easier if needed. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutouts must be facing straight up. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. The tips should completely hide the factory pipe edge.