BMS F Chassis 3.5" Billet N55 & B58 Exhaust Tips (Pair)

  • $179.00
Shipping calculated at checkout.

SKU: N55/B58 Angle Tips Ceramic

Upgrade to Larger 3.5" Angle Cut Billet Exhaust Tips

The most noticeable part of your exhaust system is the tips. Now you can get that custom look with these 3.5" billet exhaust tips on your N55/B58 BMW. No welding or cutting is needed. These are a direct bolt-on to your factory muffler. Machined from a solid block of billet aluminum and equipped with dual set screws so they go on easily and stay in place. No clamps for a clean appearance. Available in Matte Black Ceramic and Polished Silver. Made in USA. 

Not for use with M-Performance exhaust systems.

BMS BMW exhaust Tips

To install remove your factory BMW exhaust tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. You can spray some lubricant inside the tip to make it a little easier. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutouts in the rear must be facing straight up. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. Then tighten the supplied set screws with an allen hex wrench. A liquid thread locker is recommended. 
 

What's included
(2) Billet aluminum exhaust tips
(4) M8 x 1.25 x 12L  internal hex set screws 

Install Video:

18307610633 burger motorsports b58 n55 bmw 335 435 140 235 340 440 140 240 exhaust tips muffler

18307610633 burger motorsports b58 n55 bmw 335 435 140 235 340 440 140 240 exhaust tips muffler